I'm having trouble .
I have DSpro+ and two old MelcosEMC10 and EMC1.
They were comunicating last week today they are not. When I turn on Melco instead of getting the powerup I get EPBIOS & UNIT NUMBER.
I checked the power and it is at 5.1 on the EMCs
I have a trouble shooting sheet . It tells me to make sure machine is enabled . where do I do that?
and /or
Then to configure. How do I do this with the new software?
We have had loads of thunderstorms here but I leave the machines unplugged and the computer is on a super surge protector.
TIA
Kathy
I have DSpro+ and two old MelcosEMC10 and EMC1.
They were comunicating last week today they are not. When I turn on Melco instead of getting the powerup I get EPBIOS & UNIT NUMBER.
I checked the power and it is at 5.1 on the EMCs
I have a trouble shooting sheet . It tells me to make sure machine is enabled . where do I do that?
and /or
Then to configure. How do I do this with the new software?
We have had loads of thunderstorms here but I leave the machines unplugged and the computer is on a super surge protector.
TIA
Kathy
Comment