Just wondering if someone has had this problem. I am trying to put lettering on the side of a cap. I am using the XT WACF and when I try to do a trace, the machine goes clunk and I get the X Motor error.
I have used the XT WACF a lot but only for the front of the cap and this works fine.
Am I doing something wrong? Is there some setting I need to change?
Any help would be appreciated.
Thanks,
Amy in Indiana
I have used the XT WACF a lot but only for the front of the cap and this works fine.
Am I doing something wrong? Is there some setting I need to change?
Any help would be appreciated.
Thanks,
Amy in Indiana
Comment