Bobbin showing on top of design

[Dan]

We get our designs digitized for us. We have never had a problem with any of their designs. I just received one I need to get out for tomorrow and the bobbing looks like it is pulling thru the design. I have rechecked the tension and can't figure it out. I thought maybe the design was too dense so they revised it. Any suggestions- it always happens at night when their customer service is closed.

I will try to post the picture of the design.

Thanks in advance



[ September 24, 2009, 10:22 AM: Message edited by: levelbest ]

[Greenwing]

try increasing your bobbin tension and raise your lower thread feed limit by 3 ( if it is set to 2 set it to 5.
or increase your material thickness.
any of these will help.

How did you get the photo to post on the group
that is nice.

[Dan]

I'll try them thanks.

I enrolled in photobucket.com and post my pictures that I want to post in forums. Then attache the Link Code for HTML for websites and blogs. It works really well.

Thanks for your help

[Rod or Sharon]

Try using you Column Feed and Run Fill tools located in Settings, Thread Feed. It is primarily what these tools are useful for, both in Standard or Auto Activ-feed..

I will sometimes use these tools while using auto activ-feed in the Standard mode to have more control over the material thickness if auto acti-feed doesn't give me what I want.

Rod Springer
Amaya Tech & Trainer

[Dan]

I actually ended up switching the Acti-feed from auto to standard and it worked fantastic.

Thanks to all.

Dan & Terry