Hello everyone,
A customer gave us a dst file of his logo to embroider. The problem we're having is that we can't get the design to trim between elements or letters. There is a lot of small lettering that needs trimming and its impossible to do it by hand. I tried saving the file as an ofm and adjusted the "trim if less than" setting but no luck.
Any suggestions?
Thanks,
Chris
A customer gave us a dst file of his logo to embroider. The problem we're having is that we can't get the design to trim between elements or letters. There is a lot of small lettering that needs trimming and its impossible to do it by hand. I tried saving the file as an ofm and adjusted the "trim if less than" setting but no luck.
Any suggestions?
Thanks,
Chris
Comment