I know, I'm not the first. . . I have looked and looked, read all the posts, tried everything I could think of, and some things that I saw here - nothing is working. Unless I missed something somewhere. . .
Here's whats been going on: stitches fine (once its going), then trims, and every time the thread comes out of the needle. I thought the trimmer blade must be the issue, so i got a new one, installed it and thought I had it figured out until today. Now it trims just fine, not "pulling" - but the thread up top is coming out of the needle on every trim. Makes a 2 minute simple logo hell..... I even went so far as to remove the trims from the design just so I can get this job done, but.....this is driving me nuts.
I have checked everything I can think of: rebooted both machine and software, checked settings, tail set to long, checked actifeed - the stitching tells me that it's ok; checked bobbin tension; cleaned everything top to bottom. . .
any thoughts?
Here's whats been going on: stitches fine (once its going), then trims, and every time the thread comes out of the needle. I thought the trimmer blade must be the issue, so i got a new one, installed it and thought I had it figured out until today. Now it trims just fine, not "pulling" - but the thread up top is coming out of the needle on every trim. Makes a 2 minute simple logo hell..... I even went so far as to remove the trims from the design just so I can get this job done, but.....this is driving me nuts.
I have checked everything I can think of: rebooted both machine and software, checked settings, tail set to long, checked actifeed - the stitching tells me that it's ok; checked bobbin tension; cleaned everything top to bottom. . .
any thoughts?
Comment