FrastFrame Z axis problem

[Dave]

When I place the ff in my Amaya XT, I cannot get the Z axis to move back so as to access the sewing field. The frame points OUT and the head does not move in far enough to access sewing field. It's almost like the frame was built backwards or my head should move more?

If I hit the E stop I can move the head back by hand ; however, when I turn the E stop off and try to move the head it only moves out, until it is centered again?

Any ideas?

Thanks, Dave

[Juli in Kona]

I assume that you have that particular frame selected for a hoop. Make sure you have the right one selected. Which one are you using? Is the Hoop Limits turned on or off? You might want to turn them off and see if that helps.

Juli in Kona

[Dave]

Hi, Juli

I went back and verified that I did have the correct hoop selected. Turning limits off has no effect either.

If I was to flip the hoop 180 degrees, it would be perfect except for the fact that it is then raised to far above the needle plate? I was going to post a pic, however, it seems attachments is disabled.

Thanks, Dave