I just ran through the 4M stitch maintenance. I oiled the needle bars and it told me that it was going to move on to the Thread Feeder Maintenance. Then, rather than moving on, the message that I had successfully completed the 4M maintenance came up and the maintenance process closed "normally". This is the second time this happened. I am running AOS Flex+ v. 9.00.099.
While I hate doing the thread feeder maintenance, it has to be done and I can do it manually. But what is the story with the software?
David Sklar
Ballyhoo!
Alexandria, VA
While I hate doing the thread feeder maintenance, it has to be done and I can do it manually. But what is the story with the software?
David Sklar
Ballyhoo!
Alexandria, VA
Comment