Machine won't restart - Help Please

[Terri H]

I pressed the regular stop button as I had a thread fraying. When I did that I noticed the laser light also went off. After trimming and rethreading, pressed the green start button. Nothing happens. The green status light is blinking. The message on the computer in the bottom bar says "machine is stopped because the operator stopped".

Thanks,

Terri

[Just Sew It]

Terri, you must have pressed the big red button. Try twisting it and see if that works.
Jo

[Rod or Sharon]

It sounds like you put the machine to sleep. Press in the little red (stop) button and hold for 5 seconds then press the green button again and hold for 5 seconds or so and see if it wakes back up. You should be good to go.
Sharon

[Terri H]

I think it may have been asleep.... Not sure how it happened.... but after fretting as to how to get it going when it was 90% done on a jacket back stressed me to not think.