Thread Grabber

[crossthread]

Does anyone know how to adjust the Thread Grabber. One of my machines has been off since day one and I should adjust it. Can someone please direct me to a tutorial or some kind of manual?
Thank you,
Pam

[EEAmayaTech]

Hi Pam,
There are 2 adjustments that can be made. You can adjust the velcro part up and down or you can adjust the grabber in and out.
Velcro part is is At the bottom of the needle case lower left, there is a 3mm screw on the right side of the needle case there are 7mm nuts. You can then move it up and down to help it align with the grabber.
Grabber bar in and out is done at the upper left of the needle case. There is a circuit board sitting right above a large black disk.
Loosen the 2 screws holding the circuit board and you will be able to slide it front and back, hence setting how far back the grabber bar will go when it is in the velcro.
Good Luck,
TJ Michigan.

[crossthread]

Thank you TJ for your advice, I will try this and let you know.
I really appreciate your help.
~Pam