I was stitching along, this fine Sat. a.m., trying to catch up and in the middle of a polo shirt that I've done several of, the needle broke and the machine made a clacking noise, as if it were hitting the hoop. This is the middle of the design, by the way.
Now the needle is down, and when I go into maintenance to bring it up, it will not work and I get an message that reads:
Head 01-Z position error-machine took too long to do command or get to head up.
It will not do anything and I am stuck!
Any suggestions to get my Amaya back up and running?
Thanks very much for any help you can give to me!
Now the needle is down, and when I go into maintenance to bring it up, it will not work and I get an message that reads:
Head 01-Z position error-machine took too long to do command or get to head up.
It will not do anything and I am stuck!
Any suggestions to get my Amaya back up and running?
Thanks very much for any help you can give to me!
Comment