Tweet
Hey there,
I'm a complete noob and am trying to develop an applique workflow.
My media is a sublimated 100% poly patch about 4x4.5 chest logo style....
The poly is VERY slick and a little stretchy, I am looking to source a firmer media to sublimate on as well..but till then
any ideas on the issue of the media getting pushed<( sorry not sure the term here) by the needle?
Do I adjust the foot height for this procedure?
Is there a less aggressive tack down stitch I can use to lock it in?
Whats the best way to hold it down initially? I used tack from my screen print shop, it didn't do too well...
It looked like the glue actually made the needle sticky and lift the material back up when it stitched....
My first 2 attempts were actually marketable but real tricky.. I will get this, just looking for any tips to help me out along the way......
THANKS!!!
I'm a complete noob and am trying to develop an applique workflow.
My media is a sublimated 100% poly patch about 4x4.5 chest logo style....
The poly is VERY slick and a little stretchy, I am looking to source a firmer media to sublimate on as well..but till then
any ideas on the issue of the media getting pushed<( sorry not sure the term here) by the needle?
Do I adjust the foot height for this procedure?
Is there a less aggressive tack down stitch I can use to lock it in?
Whats the best way to hold it down initially? I used tack from my screen print shop, it didn't do too well...
It looked like the glue actually made the needle sticky and lift the material back up when it stitched....
My first 2 attempts were actually marketable but real tricky.. I will get this, just looking for any tips to help me out along the way......
THANKS!!!