Tweet
I have a customer that would like his initials on his shirt cuff. I have tried to do this and mine do not look "crisp" and clean like ones I've seen. Any suggestions/hints on how to do this small lettering and have it look good? I've tried several block fonts (they want a block look), about .25 in a variety of densities and I'm just not liking any of them. I'd appreciate any info on what works best for you. Thanks so much!
-
Blessings~cindy -
the melco micro block works fairly well.
density 4.2 to 4.4
ad 1 or 2 points of pull comp to the letters.
a center walk underlay.
I have even used a edge walk with a 4pt margin but that is not necessary and makes the letters stand up a bit. -
Thank you...do you do yours .25 in height?
I don't know if I know how to add 1-2 points of pull comp...is it the same as when you change the %?
There is so much I still do not know about the software and how to tweak things..thank you for your help!Blessings~cindyComment
-
no you add the points not the % it is the same window just below the %
at least in version 9Comment
Comment