create open mesh fill

[Mama Kass]

Has anyone created an open mesh decorative fill that works well? I mean the kind that uses a walk stitch to generate something that looks similar to chain-link fencing. I've tried several things, including a bottomless box-shape and an inverted right-angle "V". They seem like they're going to work, but then there are areas where the mesh isn't complete. Any suggestions?

[Juli in Kona]

Try using two fills without underlays. The ins and outs are critical.

Juli in Kona

[ckramer]

The 2 very light density fills work like a charm. I often use it under small lettering on stocking hats and heavy fleece to support the lettering. It looks just like the fencing you want to accomplish, or similar to a cross stitch, which depending on your version of DS also works nicely for the look you desire.

[Mama Kass]

This is a good idea. I was thinking of something a little heavier, using, for example, a 34 point #3 bean stitch. The needle enters at each crossing point. I've seen this done, I just can't figure out how to accomplish it.