What is going on here?
I'm using a design that I digitzed and I've run over 50 times with no issues and all of a sudden the machine with give a bobbin break error, the bobbin thread is not broken, but the machine has jumped backward in the design around 10-15 stitches.
I've tried a new bobbin, cleaned the bobbin case, the machine is clean and oiled as normal.
Sometimes the jump is in the walk stitch underlay, other times in the column stitch lettering, other times in the fill stitch portion of the design.
It hasn't done this in the previous runs with the same design file.
What in the world could be causing this?
I'm using a design that I digitzed and I've run over 50 times with no issues and all of a sudden the machine with give a bobbin break error, the bobbin thread is not broken, but the machine has jumped backward in the design around 10-15 stitches.
I've tried a new bobbin, cleaned the bobbin case, the machine is clean and oiled as normal.
Sometimes the jump is in the walk stitch underlay, other times in the column stitch lettering, other times in the fill stitch portion of the design.
It hasn't done this in the previous runs with the same design file.
What in the world could be causing this?
Comment