Tranform object outline

[Logos In Thread]

I have a digitized file which is digitized words, not key board lettering. I want to transform the lettering to curve the back of a hat. I cannot figure out how to use the "transform outline" feature and keep the correct proportions. Any help with you Version 9 gurus? I have DS ProPlus.
thanks, Linda

[Juli in Kona]

After engaging the Transform Outline, rt click the center top and center bottom to get the little circles. Now left click on one of them, hold down the Control key and click on the other one. Now they will move together.

I was just using this feature yesterday to make a fat, bulgy, wavey lettering that I did in Puff Foam. Came out super!

Juli in Kona

[Logos In Thread]

Juli, Thanks for the tips on the Transform Outline feature. I knew there had to be some way to accomplish what I wanted to do. I was finally able to get your suggestion to work.
Thanks again. I am going to conquer this DS V 9 yet!.
Linda
Logos In Thread

[Juli in Kona]

Did you figure out how to bulge it out on the sides? I finally figured it out.

Juli in Kona