Tweet
This is very soft and thin but dense weave/material, and I don't want a stabilizer to remain on either side between the stitches after sewing. I was going to use two or three layers of lightweight EZee Aqua on each side, top and bottom, without wetting or steaming afterwards. I just need something that will tear away real easy but hold the scarf sufficiently while sewing. The sew-out is mostly column letters, about an inch tall and letter width between 15 and 25 points and I thought to try an edge underlay to hold the width and run a higher MT just keep it from drawing up. Should I try to change some of the amaya settings like the column feed or fill/run feed? What about density or needle style (ball-point?) and size (smaller or larger to spread the fibers)?
- Attention New Users - this forum is MODERATED!
All registrations are checked by a live human being to prevent spam and may take a few minutes to a day or two be approved. We thank you in advance for your patience and look forward to having you be part of our community!