DS+ Custom fills ??

[Juli in Kona]

Is it possible to create a savable custom stitch for columns? Maybe if I just make it an area but long and narrow, I could use a custom fill. But if the "column" was 1/2" at the bottom and narrowing up to 3/8" at the top, and if I had a fill that was like the bow, could I make it be one bow wide at the 1/2" end and still be one bow, but a much smaller bow, at the narrow end? Think of a feather - long spikies at the bottom and short spikies at the top, each connected at the center.

Anyone doing anything along these lines? I haven't heard any discussion on this topic.

Juli in Kona

[The Embroidery Authority - OLD]

What??

Are you talking about a bow like in a Bow Tie or bow like in a Bow and Arrow?
If you say you have Pro Plus, then you can do just about anything that's possible in embroidery.
But to answer your question,.. yes, you can create a savable customer stitch for anything.
Seriously, create your custom stitch and then save it. Next time you need it "insert" it from the hard drive and there you go.
I'm just not sure if I understand the rest of your question.
Ed