Tweet
On occasion, I notice in some smaller lettering, there appears to be a hole where the white bobbin thread shows at the tie off point. (Just a dot) Is this because the no. of point width of tie off needs to be set longer (or higher) in the properties tab? I have tried changing the style of tie off, but no success.
Also, I have noticed in the newer version of DS the alphabet code sheets for ties is different on some fonts than older versions. Question, if design contains a font from a previous version that has ties already digitized into it, and one opens it in say DS 10 to edit it for some reason, do those ties now change to the newer version that perhaps do not contain pre-digitized ties in the font and now we must add ties?
Also, I have noticed in the newer version of DS the alphabet code sheets for ties is different on some fonts than older versions. Question, if design contains a font from a previous version that has ties already digitized into it, and one opens it in say DS 10 to edit it for some reason, do those ties now change to the newer version that perhaps do not contain pre-digitized ties in the font and now we must add ties?