Hello everyone, I am new to this forum.
I am having trouble with my machine. I keep getting the "Z axis timeout error" massage every time it CUTS. It sews just fine. It only messes up when it cuts the thread. I have tried it on every presser foot level, and still no success.
When it cuts I hear a loud thud, or banging noise. And the thread gets tucked up under the bobbin handle. (The little thing you flip out to hold the bobbin that also locks it in place).. I don't know how the thread gets under the handle, but it does. I use the maintenance head timing, to raise the head up, and and untangle it manually, and then proceed to sew again.
Again, it sews perfectly, just when it goes to cut, it bangs, tangles, and gives me the "Z axis timeout error" message. Can anyone help me solve this problem??
Many thanks in advance for your help!!
I am having trouble with my machine. I keep getting the "Z axis timeout error" massage every time it CUTS. It sews just fine. It only messes up when it cuts the thread. I have tried it on every presser foot level, and still no success.
When it cuts I hear a loud thud, or banging noise. And the thread gets tucked up under the bobbin handle. (The little thing you flip out to hold the bobbin that also locks it in place).. I don't know how the thread gets under the handle, but it does. I use the maintenance head timing, to raise the head up, and and untangle it manually, and then proceed to sew again.
Again, it sews perfectly, just when it goes to cut, it bangs, tangles, and gives me the "Z axis timeout error" message. Can anyone help me solve this problem??
Many thanks in advance for your help!!
Comment