I have two Amayas 2005 and 2008. Both are XTs (or at least the 2005 has the round bobbin arm) . Sewing caps on them, same design, but on the 2008, the lettering columns widths are much thinner and look crappy compared to the 2005. Checked x-cable tension with the gauge plate and it is in spec (i did replace this cable earlier this year though).
My question is, what else could be the culprit? I do notice the cap driver moves more smoothly left to right on the 2005 (when not attached to the carriage). This is the older one piece cap driver, where as the 2008 is the two piece driver assembly. I also sew at 1100 spm on caps (usually 1200 spm on flats).
My question is, what else could be the culprit? I do notice the cap driver moves more smoothly left to right on the 2005 (when not attached to the carriage). This is the older one piece cap driver, where as the 2008 is the two piece driver assembly. I also sew at 1100 spm on caps (usually 1200 spm on flats).
Comment