Announcement

Collapse
No announcement yet.

Amaya OS10 design origin lines off

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Amaya OS10 design origin lines off

    HELP!! My design registration line for the vertical is off 1/2 inch all of a sudden. Everything stitches fine. Placement is just off and it kicks in the hoop limits even though the the design looks centered in the hoop on the screen. I have a big job to finish by Monday. Please help if you have ideas
    Thanks.
    Jim [email protected]

  • #2
    Here's a quote from Juli in Kona from a previous thread:

    "Over on the right hand side (in OS) there is a button that will center the design in the hoop. Then in the upper left there is a button that will center the design. When in doubt, click on both buttons - one at a time. That should center everything."

    Give it a try.

    Comment


    • #3
      I've already tried that and nothing changed. On screen the design looks centered in the hoop but the lines are not.

      Comment


      • #4
        I hit a wrong button once, and changed the location of where my crosshairs changed. My system is sleeping right now, but I think it's something with the X Y offset in the hoop set up? Somebody help me here!

        Comment

        Working...
        X