I have 2 Amaya XTS, I was running a 19K logo on 24 shirts and pullovers. Machines were running great until the last 3 or 4 pieces. I did maintence on machines before I started, new needles etc. All of the sudden one of the machines seemed to come unthreaded and backlash so that the thread was everywhere, all the way up to the red feed rollers.
I thought it was a timing issues but we checked hook timing, and many of the other critical measurements. The cable was off we corrected that and there was a lot of improvement.
Still having upper thread moving unattached or breaking, and the thread sensors not
Icing up on it and thread being feed everywhere.
Any suggestions would be greatly appreciated!
I thought it was a timing issues but we checked hook timing, and many of the other critical measurements. The cable was off we corrected that and there was a lot of improvement.
Still having upper thread moving unattached or breaking, and the thread sensors not
Icing up on it and thread being feed everywhere.
Any suggestions would be greatly appreciated!
Comment