Shredding / Breaking Thread
I am a new owner of 2 Amaya XTS machines and new to embroidery.
I was hoping someone could look at the picture and offer suggestions as to why the blue fill stitches seemed to sew nicely but when working on the wing, I continued to have thread shredding and breaking issues.
I've tried adjusting the acti-feed, it is set on standard with 1 being in setting.
I've read most of the posts in the forum relating to shredding and have followed the procedures to check presser foot height and head timing.
I had a similar shredding breaking issue with the white at the top of the design.
Any help would greatly be appreciated.
(I haven't received any training, I wasn't aware that phone support was going to cost me $600.). That'll have to wait until after I make the next two tuition payments for the semester.
I am a new owner of 2 Amaya XTS machines and new to embroidery.
I was hoping someone could look at the picture and offer suggestions as to why the blue fill stitches seemed to sew nicely but when working on the wing, I continued to have thread shredding and breaking issues.
I've tried adjusting the acti-feed, it is set on standard with 1 being in setting.
I've read most of the posts in the forum relating to shredding and have followed the procedures to check presser foot height and head timing.
I had a similar shredding breaking issue with the white at the top of the design.
Any help would greatly be appreciated.
(I haven't received any training, I wasn't aware that phone support was going to cost me $600.). That'll have to wait until after I make the next two tuition payments for the semester.
Comment